I applied through university. The process took 2 days. I interviewed at Larsen & Toubro (Calicut, Kerala) in Nov 2012
Interview
Initially there was an aptitude test following a preliminary screening based on CGPAs and other criteria specified. Following selection in the test there was a single Technical-cum-HR interview. The interview was nearly 45 mins long in my case and was nearly 90% technical.
Interview questions [1]
Question 1
Technical questions were asked on Geotechnical which I found rather difficult.
I applied through university. I interviewed at Larsen & Toubro (Chennai)
Interview
Comfortable. Giving time to answer after every question. Also giving hints. Started with introduction, questions on internships and core and ends with basic hr questions and asked about our area of interest.
Interview questions [1]
Question 1
Thermodynamics, heat Transfer, material science basics
The process includes a group discussion followed by one technical round focused on core bachelor's principles, so there is no need to worry about extremely complex or difficult questions here.
I applied through university. I interviewed at Larsen & Toubro (Chennai) in Feb 2026
Interview
First started asking about my basic introduction. Then Current project details. Then Basic mechanical engineering questions. Speaking about a topic for 2 mins. Then about my hobbies. Asking about higher studies plans and relocation availability. Asking about any physical disorders. Are you open to physical jobs and not only desk job