I applied online. The process took 1 day. I interviewed at Arm (Bengaluru) in Feb 2018
Interview
Interview was for Graduate Engineer, Verification profile. First round was written test consisting of aptitude, C and microprocessor related questions. Two technical rounds followed by hr manager and hr interview. All rounds were on the same day. First and second technical interview to check the knowledge on microprocessor, C, verilog programming, Digital design, academic project.
Interview questions [1]
Question 1
Pointers in C, Priority encoder, write a verilog code for 2:1 mux, instruction cycle and machine cycle, Assembly level program
Thank you so much for taking time in writing a review about your experience at Arm. We are glad to know that you had a good interviewing experience. Thank you for choosing Arm and We wish you good luck in all your future endeavors.
I applied through an employee referral. I interviewed at Arm (San Diego, CA) in Apr 2026
Interview
1st was a hirevue interview - basic behavioral questions
2nd round was a panel interview - discussion on your resume and technical questions related to power and designing low power circuits
Interview questions [1]
Question 1
Given two processors, how would you determine which is better in terms of power (think about frequency, VDD, temperature etc)
Given a boolean logic, how would you reduce power in this
CV and then virtual interview then final interview through online call. It was basic interview about CV and some technical questions. It was not too difficult and intimidating. Technical interview depends on the role you apply for.
Interview questions [1]
Question 1
What was a difficult problem you encountered during your studies and how did you overcome it.
Interview was done online remotely with a manager and a graduate employee. General questions about previous experience and CB. Then followed by a live code session in Arm assembly with various technical questions.
